I would like to show you various steps to be achieved to wanted design on motorcycle parts. In the demonstration, it is a gaz thank of motorcycle on which I must paint an Indian going out of feathers. Here's the steps:

I'm proceeding as follow:

Step 1:

I draw my drawing on special tracing paper with paper pencil for the desired design on the tank of the motorcycle.

Step 2:

preparation of the tank, I hide all the contour of the drawing with special paper to protect the thank. Surface to be painted being ready, I bring back my drawing.

Step 3:

First, I paint the top of my Indian. (Half of the Indian)

Step 4:

Having the indian painted and protected with special paper, thus I then start to paint the first feather top.

Step 5:

I continu painting the second feather of the center

Step 6:

At the third feather (low), I paint the remainder of the Indian to gives him the effect to be in the interior of the feathers.

Step 7:

Three feathers finitions.

Step 8:

removal of the mask of the Indian for finishing the connection between the feathers and the Indian which will give him the effect that it comes out of the feathers

Step 9:

completion of the central veins of the feathers.

Step 10:

making the handle of the fan-shape.

Step 11:

completion of the decorations typically Indian.

Here is the final result, where in any last I make the shade of the contour to give it the effect of the fan-shapped to be on the tank.



Here is the other thank side



A closer look...